PL EN
EDM of Aluminum Alloy 6061 Using Graphite Electrode Using Paraffin Oil and Distilled Water as Dielectric Medium
,
 
 
 
More details
Hide details
1
Mechanical Engineering Department, UET Taxila, Pakistan
 
2
Mechatronics Engineering Department, UET Taxila, Pakistan
 
 
Publication date: 2017-09-03
 
 
Corresponding author
Shahid Mehmood   

Mechatronics Engineering Department, Fracture Mechanics Lab, MED, UET Taxila, 47050 Taxila, Pakistan
 
 
Adv. Sci. Technol. Res. J. 2017; 11(3):72-79
 
KEYWORDS
TOPICS
ABSTRACT
EDM machining of Al 6061 was performed under varying condition of pulse current and pulse duration. Graphite was used as an electrode material with distilled water and paraffin oil as two different dielectric mediums. The aim is to characterize the surface integrity produced as a result of EDM machining under varying both electrical and non-electrical parameters as it is important in determining the service life of EDM machined components. The vertical, horizontal and corner surfaces are independently studied for each single set of conditions. The average white layer thickness (AWLT) and surface roughness was found to be dependent on pulse current values and pulse duration. Dielectric medium has also influence on the thickness and nature of white layer. It was found that the thickness and nature of white layer formed for distilled water is different from that of paraffin oil. New methods of AWLT and surface roughness measurement through optical microscope are described. The surface roughness method developed was also calibrated against an identical surface roughness tester. Finally material removal rate, tool wear rate, the presence of micro cracks, voids and globules were compared for different conditions and conclusions were drawn according to the actual physical conditions during machining.
Journals System - logo
Scroll to top