2D Geometric Surface Structure ANN Modeling after Milling of the AZ91D Magnesium Alloy
More details
Hide details
1
Department of Organisation of Enterprise, Management Faculty, Lublin University of Technology, ul. Nadbystrzycka 38, 20-618 Lublin, Poland
2
Department of Production Engineering, Mechanical Engineering Faculty, Lublin University of Technology, ul. Nadbystrzycka 36, 20-618 Lublin, Poland
Publication date: 2022-04-01
Corresponding author
Monika Kulisz
Department of Organisation of Enterprise, Management Faculty, Lublin University of Technology, ul. Nadbystrzycka 38, 20-618 Lublin, Poland
Adv. Sci. Technol. Res. J. 2022; 16(2):131-140
KEYWORDS
TOPICS
ABSTRACT
The paper presents the results of modeling 2D surface roughness parameters in milling by means of an artificial neural network (ANN). The AZ91D magnesium alloy was used. A HSS milling cutter was employed in the research. The main aim of the study was to obtain the lowest possible surface roughness (good quality) using a commonly available HSS cutter. The results of the research work were presented in the form of bar charts, surface charts and graphs depicting the quality of artificial neural networks. The conducted research shows that it is possible to carry out the machining processes that enable obtaining an average surface quality (defined by roughness parameters Ra, Rz, RSm, Rsk). The Ra, Rz, RSm parameters increase along with the machining parameters (fz, ap), as expected. The Rsk parameter takes (in most cases) negative values, which may indicate a surface with more intense friction and indicative of flat-topped distribution. On the other hand, the results of modeling the selected parameters – Ra, Rz, RSm – with the use of artificial neural networks allow concluding that the obtained network models show satisfactory predictive ability (R = 0.99), and thus are an appropriate tool for the prediction of surface roughness parameters.