PL EN
 
PL EN
Bieżące wydanie
O czasopiśmie
Rada Naukowa
Redakcja i Wydawca
Opłaty za publikacje
Open Access
vol. 19, 9, 2025
Statystyki
CC-BY 4.0
Pobierz cytowanie
The influence of polymer materials and internal density on the parameters of fused filament fabrication samples during tensile testing
Małgorzata Ewa Gontarz-Kulisiewicz 1
,
 
Grzegorz Budzik 1
,
 
Tomasz Dziubek 1
,
 
Bartłomiej Sobolewski 1
,
 
Łukasz Przeszłowski 1
 
 
 
Więcej
Ukryj
1
Faculty of Mechanical Engineering and Aeronautics, Rzeszów University of Technology. Al. Powstańców Warszawy 12, 35-959 Rzeszów, Poland
 
 
Autor do korespondencji
Małgorzata Ewa Gontarz-Kulisiewicz   

Faculty of Mechanical Engineering and Aeronautics, Rzeszów University of Technology. Al. Powstańców Warszawy 12, 35-959 Rzeszów, Poland
 
 
Adv. Sci. Technol. Res. J. 2025; 19(9)
 
SŁOWA KLUCZOWE
3D printing
ABS
PLA
static tensile test
internal structure
FFF method
internal infill
 
DZIEDZINY
 
STRESZCZENIE
This article presents a strength analysis of selected polymer materials (ABS (acrylonitrile butadiene styrene), PLA (polylactic acid), HABS (hard acrylonitrile butadiene styrene), HIPS (high-impact polystyrene), PC/ABS (acrylonitrile butadiene styrene with polycarbonate), and S&S (strong and soft)) used in the FFF method based on a static tensile test. Standardized type 1A specimens with varying filling densities of the internal grid structure were tested, specifically at densities of 13%, 15%, 20%, 65%, 80%, and fully filled. Additionally, the fractures of the samples following the strength tests were examined and described.
Udostępnij
Wyślij mailem
ARTYKUŁ POWIĄZANY
Mechanical behavior of 3D printed polymers under tensile and bending loads
Mechanical characterization of composites containing carbonized furniture waste in static tensile testing
Analysis of the influence of the distribution of recyclate rubber layers in the sandwich composite on the identification of damage initiation stress of composite materials using the acoustic emission method
Partial maxillofacial reconstruction: design and additive manufacturing of individualized pre- and mid-surgery supplies
Analysis of fused filament fabrication / fused deposiotion modelling applications for production of casting patterns used in sand casting
Journals System - logo
© 2006-2025 Journal hosting platform by Bentus
Scroll to top