PL EN
TECHNOLOGY OF HEAT TREATING-STRAIGHTENING OF LONG SHAFTS WITH LOW RIGIDITY
Antoni Świć 1  
,   Aleksandr Draczew 2,   Arkadiusz Gola 3  
 
Więcej
Ukryj
1
Institute of Technological Systems of Information, Lublin University of Technology, Nadbystrzycka Street 36, 20-618 Lublin, Poland
2
Faculty of ТМ, Togliatti State University, 12 Belorusskaia Street 445021, Tоgliatti, Russia
3
Department of Enterprise Organization, Lublin University of Technology, Nadbystrzycka Street 38, 20-618 Lublin, Poland
AUTOR DO KORESPONDENCJI
Antoni Świć   

Lublin University of Technology, Institute of Technological Systems of Information, Nadbystrzycka 36, a.swic@pollub.pl Lublin, Poland
Data publikacji: 01-09-2016
 
Adv. Sci. Technol. Res. J. 2016; 10(31):207–214
 
SŁOWA KLUCZOWE
DZIEDZINY
 
STRESZCZENIE
The paper presents a new method of heat treating-straightening of long shafts with low rigidity. Analytical relationships for the determination of rectilinearity of shaft axis in heat treating- straightening are presented. A fixture for heat treating-straightening of shafts was developed. The experiment conducted as well as the calculations confirm high effectiveness of the developed method of heat treating-straightening of long shafts with low rigidity. Application of the developed technology of heat treating-straightening permits minimisation of the value of deflection of semi-finished product and stabilisation of the level of residual longitudinal stress, which results in enhanced operational accuracy of long shafts with low rigidity, improved quality and operation parameters of finished products.