The dimensional accuracy of injection molded parts plays an increasingly significant role in the plastics processing industry, as is the utilization of recycled raw materials. To obtain the desired dimensions and properties of injection moldings, various material modification methods are used simultaneously. The conducted research aimed to assess the impact of hybrid modification of non-nucleated heterogeneously isotactic polypropylene using recovered phosphogypsum and a chemical blowing agent on the shrinkage value and mechanical properties of injection molded parts. Additionally, changes in dimensions and properties of composites with solid and porous structures that occur within 1000 hours of their removal from the injection mold were determined. The research showed that the filler used acts as a nucleating agent causing an increase in the shrinkage of the parts, up to 10 wt%. Similar changes were observed in the case of tensile strength. The increase in the value of this parameter at the lowest phosphogypsum contents used was most likely the result of changes in the crystalline structure of polypropylene. Changes in the mechanical properties of the molded parts that occurred during conditioning are correlated with shrinkage changes that occur from the moment the molded parts are removed from the injection mold. Young's modulus and tensile strength increased linearly for both solid and porous moldings. However, the rate of stiffness increases as a function of shrinkage changes with the filler content. Nevertheless, the opposite tendency was observed in the case of changes in impact strength, the values of which decreased as a function of shrinkage to the greatest extent in the case of unfilled polypropylene.