PL EN
Comparative Analysis of Tube Piercing Processes in the Two-Roll and Three-Roll Mills
 
Więcej
Ukryj
1
Mechanical Engineering Faculty, Lublin University of Technology, Nadbystrzycka 36, 20-618 Lublin, Poland
 
 
Data publikacji: 01-03-2019
 
 
Autor do korespondencji
Zbigniew Pater   

Mechanical Engineering Faculty, Lublin University of Technology, Nadbystrzycka 36, 20-618 Lublin, Poland
 
 
Adv. Sci. Technol. Res. J. 2019; 13(1):37-45
 
SŁOWA KLUCZOWE
DZIEDZINY
 
STRESZCZENIE
The article presents a comparison of the piercing process conducted in a two-roll Diescher mill and a three-roll mill. The comparative analysis was based on the numerical simulations of the aforementioned processes, obtained using Forge NxT 1.1. software. It was stated that the most favourable manufacturing method is skew rolling in three-mill rolling mills. The mills operating in this scheme are less energy-consuming, whereas the manufacturing time is 30% shorter.
Journals System - logo
Scroll to top