PL EN
Vertical Forces Acting on the Lock-Off Element of the Pallet Brake System
 
Więcej
Ukryj
1
VSB Technical University of Ostrava, Faculty of Mechanical Engineering, Institute of Transport, 17. listopadu 2172/15, 708 00 Ostrava - Poruba, Czech Republic
 
2
VSB Technical University of Ostrava, Faculty of Electrical Engineering and Computer Science, Department of Electrical Engineering, 17. listopadu 2172/15, 708 00 Ostrava - Poruba, Czech Republic
 
 
Data publikacji: 01-03-2020
 
 
Autor do korespondencji
Leopold Hrabovský   

VSB Technical University of Ostrava, Faculty of Mechanical Engineering, Institute of Transport, 17. listopadu 2172/15, 708 00 Ostrava - Poruba, Czech Republic
 
 
Adv. Sci. Technol. Res. J. 2020; 14(1):116-126
 
SŁOWA KLUCZOWE
DZIEDZINY
 
STRESZCZENIE
The paper presents an experimental device that was created in order to obtain real values of the forces acting in vertical direction on the lock-off element, the so-called brake body, the 2nd design option. The lock of this design is used in the automated parking garage, designed by KOMA - Industry, s.r.o, to lock the parked vehicles on pallets in the units of the rack parking system. The forces acting in vertical direction on the body of the fixation lock when pushing the brake pulley into the circular recess in the brake ramp are theoretically calculated for two design variants of the brake ramp used in practice, i.e. "Without" and "with" a rounded (filleted) circular recess segment in the brake ramp. Experimentally determined forces acting in vertical direction on the brake body are determined for two types of compression coil springs with a rectangular cross section of the spring wire.
Journals System - logo
Scroll to top