The article focuses on the subject of 3D printing. 3D printing technology and currently used solutions are described. The materials used in printing with the use of a filament printer and a resin printer are discussed. The fused deposiotion modeling technique and the LCD-based stereolithography. Printing technology were presented. Samples were prepared using 3D modeling software. The software used to make the models is discussed. The designed models were printed on two types of printers, using different model orientations. Printouts were measured several times. The obtained data was analyzed and the conclusions, proposed solutions and possible improvements to 3D printing were presented at the end. The article deals with the subject of the possibility of accelerating 3D prints due to their location, but also the influence of warming up the printer during subsequent prints was checked.