PL EN
 
PL EN
Bieżące wydanie
O czasopiśmie
Zespół Redakcyjny
Redakcja i Wydawca
Opłaty za publikacje
Open Access
vol. 11, 2, 2017
Statystyki
Pobierz cytowanie
THE EFFECT OF PROCESS PARAMETERS ON THICKNESS DISTRIBUTION IN THERMOFORMING
Olcay Eksi 1
,
 
Sencer Süreyya Karabeyoğlu 1
 
 
 
Więcej
Ukryj
1
Kırklareli University, Engineering Faculty, Mechanical Engineering Department, Kayalı Campus, Kırklareli, Turkey
 
 
Data publikacji: 01-06-2017
 
 
Autor do korespondencji
Olcay Eksi   

Kırklareli University, Kırklareli University, Engineering Faculty, Mechanical Engineering Department, Kayalı Campus Kırklare, 39100 Kırklareli, Turkey
 
 
Adv. Sci. Technol. Res. J. 2017; 11(2):198-204
DOI: https://doi.org/10.12913/22998624/71147
 
 
Artykuł (PDF)
 
SŁOWA KLUCZOWE
thermoforming
plug-assist
thickness distribution
mold
 
DZIEDZINY
 
STRESZCZENIE
In this study, cylindrical, conical and hemispherical molds were used to form flat thermoplastic sheets which are 1.5 mm in thickness. The effect of plug assist on thickness distribution was investigated. The sheets were formed with and without plug assist. Then thickness distributions on thermoformed products were obtained for two experimental procedures by a digital caliper (Resolution: 0.01mm). As a result, plug assist thermoforming provides more uniform thickness distributions than negative forming.
Udostępnij
Wyślij mailem
ARTYKUŁ POWIĄZANY
Improve Single Point Incremental Forming Process Performance Using Primary Stretching Forming Process
Numerical and Experimental Investigation of the Effect of Strength of Aluminum 6061 Alloy on Thickness Reduction in Single-Point Incremental Forming
Thermoforming of a Polystyrene Sheet with a Vibrating Male Mold
The Effect of Selected Conditions in a Thermoforming Process on Wall Thickness Variations
An Experimental Study on Wall Thickness Distribution in Thermoforming
Journals System - logo
© 2006-2024 Journal hosting platform by Bentus
Scroll to top