PL EN
SURFACE INTEGRITY EVALUATION OF TURNING WITH AUTO-ROTATING TOOL
 
Więcej
Ukryj
1
Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 01026 Žilina, Slovakia
 
2
Faculty of Manufacturing Technologies, Technická Univerzita v Košiciach so sídlom v Prešove, Bayerova 1, 08001 Presov, Slovakia
 
 
Data publikacji: 01-09-2016
 
 
Adv. Sci. Technol. Res. J. 2016; 10(31):139-143
 
SŁOWA KLUCZOWE
DZIEDZINY
 
STRESZCZENIE
The technical practice requirements comes to have increased demands on higher productivity, speed and quality of the machining process of various materials. Hard to machine materials, whose machining led to the development of turning with rotating cutting edge are not an exception. The machining process of auto-rotating tool is more complicated than the conventional process of turning, especially for the process of reshaping cutting layers into chips. There is a significant load in the system, that may affect the life of the cutting edge of the tool as well as the whole system and also in the final extent of the qualitative parameters of the workpiece (product / product). The article specifies the knowledge and findings of measurement in machining material 100Cr6 with an auto-rotating tool. The measurements were conducted to evaluate the integrity of the surface (roughness) of the workpiece to the impacts of cutting conditions, in particular the feed and the cutting edge inclination. It also analyzes the presence (size, character, action) of residual stresses concentrated in the surface layers of the workpiece by changing the cutting conditions.
Journals System - logo
Scroll to top