PL EN
DESIGNING HYDRAULIC AIR CHAMBER IN WATER TRANSMISSION SYSTEMS USING GENETIC ALGORITHM
 
Więcej
Ukryj
1
Department of Civil Engineering, Islamic Azad University, Arak Branch, Arak, Iran
 
2
Department of Mechanic Engineering, Islamic Azad University, Arak Branch, Arak, Iran
 
 
Data publikacji: 01-09-2016
 
 
Autor do korespondencji
Abdorahim Jamal   

Department of Civil Engineering, Islamic Azad University, Arak Branch, Arak, Iran
 
 
Adv. Sci. Technol. Res. J. 2016; 10(31):1-7
 
SŁOWA KLUCZOWE
DZIEDZINY
 
STRESZCZENIE
Transient flow control in Water Transmission Systems (WTS) is one of the requirements of designing these systems. Hence, among control equipment, air chambers offer the best solution to control transient flow effects, i.e. both prevents water column separation and absorbs pressure increase. It is essential to carry out an accurate and optimized design of air chambers, not only due to high costs of their manufacturing but also their important protective role. Accordingly, hydraulic design parameters comprise tank volume, diameter of nozzle and coefficients of inflow and outflow of nozzle. In this paper, it is intended to optimize these parameters in order to minimize manufacturing costs. On the other hand, maximum and minimum pressures in main pipeline are considered as constraints which shall fall in allowed range. Therefore, a model has been developed which is a combination of a hydraulic simulation model of WTS and an optimization model based on genetic algorithm. This model is first applied to WTS of Dehgolan-Ghorveh plain as a case study. Results of this research demonstrate that based on suggested model, negative wave creation and pressure increase in pipeline is prevented as well as decrease in manufacturing costs of air chamber.
Journals System - logo
Scroll to top